Audi A4
+ Running gear
+ Regular servicing
+ Engines
+ Turbo-supercharging
+ System of an exhaust
+ Cooling system
+ Fuel tank and fuel pump
+ Air filter and channels of absorption
+ System of injection
+ Coupling
+ Transmission and main transfer
+ Suspension bracket of wheels and steering
+ Brakes
+ Wheels and tires
+ Electrotechnical equipment
+ System of ignition
+ Lighting
+ Alarm equipment
+ Tools and devices
- Heating and ventilation
Check of heating and ventilation
Supercharger of air
Replacement of the dustproof filter
Module of manual control by heating/ventilation
Search of malfunctions
Climatic installation
+ Body details
+ Salon
Search of malfunctions
Technical characteristics
|
Supercharger of air
Arrangement of the supercharger
|
|
When the box for gloves is dismantled, the engine of the supercharger with a wheel of the fan (2) is available. It is inserted into an air duct (1) from below. |
|
|
Here additional resistance of the supercharger (2 – near a thermosafety lock) are taken out from an assembly opening in a box (1) of the supercharger. Shooters showed lock springs from plastic. |
The engine of the supercharger of air works at four speeds which are established by the rotary switch "Air Supply and Supercharger" on the control panel. Various steps of speed are reached due to connection of resistance of different size (or their consecutive connection). Resistance are connected to a wire of mass of the engine of the supercharger. Giving of plus current (through a safety lock) remains to a constant – only the contact with weight "improves" or "worsens".
Search of malfunctions in the engine of the supercharger of air
|
|
- If the supercharger of air does not work in one of provisions of the switch, then check the corresponding safety lock in the beginning (the table in the head the Electrotechnical equipment).
- If, despite the serviceable switch, also screen wipers, then the reason in the H-contact unloading relay do not work.
- Check of the engine of the supercharger: completely dismantle a box for gloves (the head Salon).
- Disconnect the bipolar socket in a wire to the engine of the supercharger, connect two auxiliary wires to contacts of the engine free now: from accumulator plus to contact to which the red wire, and from accumulator minus was connected to contact to which the brown wire was connected.
- If the engine of the supercharger as it should be, then now it has to rotate at a full speed. If is not present, replace it.
- If the drive works not at all speeds, then, perhaps, defect in one of resistance.
- Dismantle additional resistance, carry out visual control. If one of resistance fused, replace all support with resistance.
- If additional resistance as it should be, then along with violation of conductivity in a wire, as a malfunction source still there can be a rotary regulator in the control panel – replace all control unit with heating.
|
|
Dismantle of the engine of the supercharger of air
|
|
- Completely dismantle a box for gloves (the head Salon).
- The engine of the supercharger is inserted into an air duct to heating from below.
- Disconnect the socket of a tokopodvodyashchy wire of the engine of the supercharger and take out a wire from an arm.
- Lift a lock ledge at the left on the case over a clamp and take out the case of the supercharger of air, having turned it to the left (counterclockwise).
|
|
Dismantle of additional resistance of the supercharger of air
|
|
- Dismantle a box for gloves (the head Salon).
- Wring out two plastic lock springs below on a fixing payment of additional resistance up.
- Raise a fixing payment and take out it down. If it is necessary, weaken glue connection.
- At installation pay attention that the main payment of resistance is completely densely established in an air duct. If it is necessary, condense it with sealant.
|
|
|
|
