Violations in work of the ABS system
At inclusion of ignition the control bulb of ABS on the control panel flashes. It has to go out when the engine starts working, or the latest at a speed which exceeded 6 km/h. If onboard tension falls lower than 10 V, then the control bulb also lights up. It can light up and in case one of wheels slips longer than 20 pages. Then again switch off ignition and anew start the engine.
If the bulb burns constantly, ABS is not ready for operation. In the workshop Audi or Bosch have to define the reason. As the fan you can check in any case shtekerny sockets of the control unit, sensors of speed or the hydraulic module. Besides, it is possible to recommend to disconnect sensors of speed and to clean their front party.
|
|
Council: Even if the control bulb of ABS burns constantly, i.e. ABS does not work, then you have to conduct the car taking into account idle system of electronic distribution of brake effort. Brakes of back wheels can be blocked relatively early. Extra care is required on turns where at Audi with the blocked back brakes can bring a back part. Carefully driving the car, find the workshop Audi. |
|
