Audi A4

since 1994 release

Manual of the car


Audi A4
+ Running gear
+ Regular servicing
+ Engines
+ Turbo-supercharging
+ System of an exhaust
+ Cooling system
+ Fuel tank and fuel pump
+ Air filter and channels of absorption
+ System of injection
+ Coupling
+ Transmission and main transfer
+ Suspension bracket of wheels and steering
+ Brakes
+ Wheels and tires
+ Electrotechnical equipment
+ System of ignition
+ Lighting
+ Alarm equipment
+ Tools and devices
+ Heating and ventilation
- Body details
   Front bumper
   Damages to result of accidents
   Frontal part of the car
   Cowl
   Wings
   Side levels
   Doors
   Dismantling of doors
   Mirror of the external review
   Trunk lid
   Rear bumper
   Sliding/removable roof
   Check of a corrosion-resistant coating of the bottom
   Clearing of openings for a water drain
+ Salon
Search of malfunctions
Technical characteristics

7c8a7ef4


Wings

Arrangement of fasteners of a forward wing (6)

1, 3, 7, 9, 11 – cut bolts with six-sided heads;
2 – cut rivet;
4 – the self-cutting screw with a crosswise head;

5, 10 – a nut from sheet metal;
8 – arm.


In the drawing two fixing bolts of a wing (1 and 2) which are available at an open forward door are shown.

Forward wings unscrew. On the contrary, back side details are strongly welded – there is no field for activity of the fan.

Dismantle of flaps of a wheel niche

 PERFORMANCE ORDER

  1. Remove the corresponding forward wheel.
  2. Hang out lateral face of a bumper from an arm on a wing. For this purpose wring out a bumper below on height of an arm and at the same time pull from a body.
  3. Weaken all fixing screws of the flap of a wheel niche.
  4. Turn on 90 ° a high-speed lock of connection with the lower facing of the engine to the left.
  5. Remove the flap of a wheel niche from expansion fingers and wring out inside from a cut for a wheel.
  6. At installation softly tighten screws, otherwise in plastic a thread will be stripped!

Dismantle of a wing

 PERFORMANCE ORDER

  1. Dismantle the flap of a wheel niche.
  2. Dismantle a bumper.
  3. Dismantle the index of turn.
  4. On bottom edge of a wing unscrew ahead one and behind two screws with crosswise heads or TORX bolts.
  5. Under a cut for the index of turn unscrew a bolt, the second – ahead in a cut for a wheel.
  6. Unscrew behind in a wheel niche the facing (closing a detail). For this purpose weaken two bolts.
  7. Now both bolts on a fixing crossing point of metal behind on a wing are available – unscrew.
  8. Open a forward door – unscrew a bolt over hinges.
  9. Unscrew bolts with six-sided heads on the upper edge of a wing.
  10. Remove a wing.
  11. At installation adjust a crack in relation to a cowl at even the weakened top fixing bolts of a wing. It has to be about 3,0 mm.