Audi A4

since 1994 release

Manual of the car

Audi A4
+ Running gear
+ Regular servicing
+ Engines
+ Turbo-supercharging
+ System of an exhaust
+ Cooling system
+ Fuel tank and fuel pump
+ Air filter and channels of absorption
+ System of injection
+ Coupling
+ Transmission and main transfer
+ Suspension bracket of wheels and steering
+ Brakes
+ Wheels and tires
+ Electrotechnical equipment
+ System of ignition
+ Lighting
+ Alarm equipment
+ Tools and devices
+ Heating and ventilation
- Body details
   Front bumper
   Damages to result of accidents
   Frontal part of the car
   Side levels
   Dismantling of doors
   Mirror of the external review
   Trunk lid
   Rear bumper
   Sliding/removable roof
   Check of a corrosion-resistant coating of the bottom
   Clearing of openings for a water drain
+ Salon
Search of malfunctions
Technical characteristics


Mirror of the external review

Dismantle of a mirror assembled

1 – fixing screw;
2 – a shaped detail from polyfoam for a noise isolation;

3 – mnogoshtyrkovy socket.

Dismantle of mirror glass (4)

1 – black facing below under a mirror;
2 – facing screws;

3 – servomotor.
Shooters showed clamps on mirror glass.

Dismantle of the case (1) of a mirror

2 – mirror arm;
3 – servomotor;

4 – mirror glass.
Shooters showed screws which the mirror case to an arm fastens.

Replacement of mirror glass

Mirror glasses in mirrors of the Audi A4 fasten only spring clips. Dismantle:


  1. Weaken below on a mirror both screws with crosswise heads and remove black facing.
  2. Shift at the same time facing aside to take out clamps.
  3. Put on working gloves if there are chips.
  4. Through an opening in the bottom of a mirror it is possible to reach about several clamps which mirror glass to a servomotor fastens.
  5. Take out available clamps from grooves the screw-driver – then it is possible to wring out glass completely.
  6. Disconnect the socket of heating of a mirror.
  7. At installation insert mirror glass into frictional springs on the case. Establish glass on a ring of a servomotor and press so that it entered clamps.
  8. Press the middle of glass and again put on gloves.

Dismantle of the case of a mirror


  1. Dismantle mirror glass.
  2. Unscrew a servomotor and remove.
  3. Unscrew three screws and remove the case from an arm up.

Dismantle of a mirror assembled


  1. Wring out the black decorative triangular panel in a triangle of forward side glass from within.
  2. Disconnect the mnogoshtyrkovy socket.
  3. Unscrew the fixing screw of a leg of a mirror.
  4. Remove a mirror assembled.

 Council: You will find information on functioning and check of adjustment of a mirror with the electric drive in the head Instrumenty and devices.